N5290/1A Option 403-(Interconnect Kit N5292-60017) - Keysight Technologies PNA Series Installation Manual

System Installation
PNA, Controller, and Test Head Module Interconnections
N5290/1A Option 403—(Interconnect Kit N5292-60017)
IMPORTANT!
The N5227B and N5247B interconnect kits contain 2.4 mm to 3.5 mm
cables. It is important to connect the 2.4 mm end to the PNA and to
connect the 3.5 mm end to the N5292A test set controller. Improper
connections will result in damage to your instruments.
It is important to use two wrenches when connecting the semirigid cables
to the 1/2/3/4 port 1.85 mm outputs front ports of the PNA to avoid
stressing the connectors and causing damage to your PNA (i.e., the
2.4 mm cable end is compatible with the 1.85 mm connector of the PNA).
Figure 3-11 on page 16
Figure 3-11 N5290/1A-403: Install semirigid cables (N5292-20014, N5292-20015, and
N5292-20016) to the front panel of the PNA and N5292A
3- 16
is used for the N5292-60017 interconnect kit.
Keysight N5290/1A Installation Guide