Summary Of Led Display Formats; Troubleshooting; Table 5 Types Of Led Display - Curtis 1222 Manual

Electric steering controller
Table of Contents

Advertisement

7 — DIAGNOSTICS & TROUBLESHOOTING
100
2 9 J A N U A R Y 2 0 1 3 D R A F T

Summary of LED display formats

The two LEDs have four different display modes, indicating the type of infor-
mation they are providing.

Table 5 TYPES OF LED DISPLAY

DISPLAY
Neither LED illuminated
Yellow LED flashing
Both LEDs on solid
Red LED and yellow LED
flashing alternately

TROUBLESHOOTING

The troubleshooting chart, Table 6, provides the following information about
each controller fault:
• fault code and sub-code
• fault name as displayed on the programmer's LCD
• possible causes of the fault
• fault set conditions and fault clear conditions
• steer fault action (effect of fault on steering)
• traction fault action (effect of fault on traction)
For each fault, the chart shows one of these four Steer Fault actions:
— The 1222 still operates normally.
Warning Only
— Immediate shutdown of the 1222 and turn-off of the fault
Shutdown
output (pin 23).
Warning then Shutdown
motor comes to a stop or the timer (set by Fault Steering Timeout) expires.
After this occurs, the Shutdown action takes place.
— The 1222 tries to hold the existing wheel position
Hold then Shutdown
regardless of operator input until the traction motor comes to a stop or the
timer (set by Fault Steering Timeout) expires. After this occurs, the Shutdown
action takes place.
Whenever a fault is encountered and no wiring or vehicle fault can be found,
shut off KSI and turn it back on to see if the fault clears. If it does not, shut
off KSI and remove the 35-pin connector. Check the connector for corrosion
or damage, clean it if necessary, and re-insert it.
Controller is not powered on; or vehicle has
dead battery; or severe damage.
Controller is operating normally.
Controller is in Flash program mode.
Controller has detected a fault. 2-digit code
flashed by yellow LED identifies the specific
fault; one or two flashes by red LED indicate
whether first or second code digit will follow.
— The 1222 continues to operate until the traction
STATUS
Curtis 1222 Manual,
os 15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents