Valid Pci Card Configurations; Introduction - Avaya CallPilot 1005r Hardware Installation

Valid PCI card configurations

Introduction

There are six PCI card slots; three low-profile and three full-size. Valid configurations of low-
profile and full-size cards are shown in the table
page 16.
Note:
Your server configuration depends on what was ordered from Avaya. Therefore, your server
may not have all of the slots populated.
When looking at the server from the rear (see
both full-size and low-profile cards are numbered from the top down.
Note:
There are two MPB96 board versions; the NTRH40AA, and NTRH40CA. The following table
compares the two boards.
Version
NTRH40AA
NTRH40CA
Important:
If you have an NTRH40AA MPB96 board, you must connect the DS30X-1 cable to an MGate
card to receive the clock source for the MPB96 board. Failure to connect the DS30X-1 cable
to an MGate card can result in noise interference on the remaining voice channels. This
restriction does not apply to the NTRH40CA MPB96 board, as it can receive clock source
from any of the three DS30 ports.
Avaya CallPilot® 1005r Server Hardware Installation
Description
Has a single DB-44 connector on its faceplate
Connects to the CS 1000 or Meridian 1 with an NTRH2014 DS30X
cable
Has three RJ-45 connectors on its faceplate
Connects to the Avaya CS 1000 or Meridian 1 with three standard
RJ-45 connectorized Ethernet cables
For more information about these cables and connecting the
NTRH40CA MPB96 board to MGate cards, see Communication
Server and CallPilot Server Configuration(NN44200-312) or
Meridian 1 and CallPilot Server Configuration(NN44200-302).
Valid PCI card configurations
Table 1: 1005r PCI card slot configurations
Back panel controls and features
on
on page 12),
December 2010 15