Meridian 1 Or Avaya Communication Server 1000 Systems; Network Requirements; Remote Access Connectivity - Avaya CallPilot 1005r Hardware Installation

Hide thumbs Also See for CallPilot 1005r:

Table of Contents

Meridian 1 or Avaya Communication Server 1000 systems

• One NIC provides connectivity to the ELAN subnet. Connect the NIC labeled NIC2-

NickP on the back of the server to the ELAN subnet.

For information about the purpose and requirements of the ELAN subnet, see the

Planning and Engineering Guide (NN44200-200).

• The second NIC, labeled NIC1-NickP can be connected to the Avaya server subnet.

This optional NIC is required only for Meridian 1 or Avaya Communication Server 1000

systems that require a Avaya server subnet connection (in addition to the ELAN subnet

connection). The Avaya server subnet provides data connectivity between desktop and

Web messaging clients, Web-enabled administrative PCs, and the CallPilot server.

Appropriate networking equipment must be available for both the Avaya server subnet and

ELAN subnet.

The Avaya server subnet and ELAN subnet must be properly configured for correct CallPilot

operation. To ensure correct configuration, Avaya recommends that you consult a network

specialist.

Use one of the USB connectors on the rear of the 1005r server to connect to an external plug-

and-play modem. The modem is used for remote administration and technical support.

RRAS is used to establish the remote access connection to the server. Use either RDC or

pcAnywhere to communicate with the CallPilot server.

Avaya CallPilot® 1005r Server Hardware Installation

Meridian 1 or Avaya Communication Server 1000 systems

December 2010

Table of Contents