Removing The Front Bezel; Introduction - Avaya CallPilot 1005r Hardware Installation

Removing the front bezel

Introduction

To access the hard drives on the front panel, you must remove the front bezel.
The front bezel covers the electrostatic discharge (ESD) connection, both hard drives, and the
DVD/CD/CDRW drive pull handle. The control panel, USB port 2, and the front comm 2 serial
port connection are not covered by the front bezel.
To remove the front bezel
1.
2. Pull the front bezel off the front panel by the captive fasteners.
3. Do not touch components on the front panel without ESD protection. Attach an ESD
Avaya CallPilot® 1005r Server Hardware Installation
Caution:
Risk of equipment damage
Do not attempt to move or lift the server before removing the front bezel; the
server can disengage from the bezel and fall.
Loosen the two black captive fasteners on either side of the front bezel.
strap to your wrist and connect it to a single point ground connection.
Removing the front bezel
December 2010 29