Edwards ModuLaser Installation Manual page 91

Type Message
Fault Display Offline
Fault Front Cover Removed Front cover removed
Fault Input 1 Open Circuit
Fault Input 1 Short Circuit
Fault Input 2 Open Circuit
Fault Input 2 Short Circuit
Fault Battery
Fault Mains
Fault Power Supply Voltage
Low
Fault Internal Memory
Fault External Memory
Fault Reset from Watchdog The device has rebooted due to a watchdog failure
Fault Date and Time Lost
Fault Detector Not
Calibrated
Fault Incompatible Versions Incompatible versions found in the network
Fault Subsystem
Fault No Pipe Calibration
Fault Invalid Pipe
Calibration
Warning Disabled
Warning Installation Test
Warning User Interface LED
Test
Warning User Interface TFT
Test
Warning User Interface Keys
Test
Warning Input Test
Warning Output Test
Warning Detection Aborted
Warning FastLearn Start
Warning Power Save Mode
Warning Flow Low Range
Warning Flow High Range
Warning Demo Mode
ModuLaser Modular Aspirating Smoke Detector Installation Manual
Chapter 4: Maintenance and troubleshooting
Description
No display module found by the detector
Input 1 open circuit
Input 1 short circuit
Input 2 open circuit
Input 2 short circuit
Battery fault reported by the power supply
Mains fault reported by the power supply
Power supply voltage low
Internal memory fault
External memory fault
Date and time lost
Detector not calibrated
Subsystem fault
Pipe calibration data not found
Pipe calibration data invalid (new pipe calibration
required)
Device disabled
The device is in installation test
The device is in LED test
The device is in UI test
The device is in Key test
The input is in test
The output is in test
Detection aborted due to one or more of the following
faults: Front Cover Removed (detector), Fan Motor, Filter
Removed, Critical Temperature
FastLearn in progress
Power Save mode enabled
Flow below absolute low range
Flow below absolute high range
Demo Mode enabled
85