Saab SONETT III Service Manual page 69

Windshield wiper motor
Removal
1. Take off the hood. See Chapter 8.
2. Back off and remove the three wiper-motor retaining
screws and pull the cable splice apart.
3. Bend the ball joint for the wiper-mechanism linkage
open. The motor can now be removed. The ball joint
is accessible through a hole above the headlight oper-
ating rod at the dash panel. See fig.
Reinstall in the reverse sequence.
THE WIPER-MECHANISM LINKAGE HAS BEEN DISCONNECTED
Adjustment of windshield wiper parking position
1. Slacken the three screws securing the gearbox cover
so that the cover can be turned.
2. Adjust to the wanted parking position and tighten the
cover.
Wiper mechanism
Removal
1. Remove the wiper arms and the nuts of the wiper
shafts.
2. Unfasten the instrument insert and pull it out slightly
so as to provide access to the mechanism.
NOTE
Notice the way in which the mechanism is turned.
It must be installed so that both wiper shafts rotate
in the same direction.
3. Back off and remove the four retaining screws for the
mechanism and collect the flat nuts. Divide the mecha-
nism in the ball joints and pull it out under the instru-
ment panel. See fig.
Reinstall in the reverse sequence.
REMOVAL OF WIPER MECHANISM
ADJUSTMENT OF PAR KING POSITION
363-2 SAAB June 1970