Saab SONETT III Service Manual page 85

CLUTCH OPERATION
Pedal stand
Removal of pedals
Each pedal can be removed separately if the pedal shaft
is removed.
1. Remove the floor mat and the wallboard panels. Re-
move the gear lever knob and rubber boot. Remove
the gear lever cover (4 screws).
2. Back off and remove the screws hold ing the pedal
plate and lift out the two parts of the later.
3. Release the clutch-pedal push-rod by removing the
cotter pin and shaft bolt.
4. Release the return springs of the brake pedal and
clutch pedal.
5. Strike out all slotted pins and pull out the pedal shaft.
6. Detach the push-rod from the rubber boot, thereby
enabling the brake pedal to be separated from the mas-
ter cylinder. When the pedal is then lifted out, it will
be accompanied by the push-rod.
Reassembly takes place in the reverse sequence.
S 1366
SLOTTED PINS, PEDAL SHAFT OIL HOLE, CLUTCH- AND BREAK PEDAL
A = 8 ± 1,5 mm
412-1
SAAB Nov. 1972