Saab SONETT III Service Manual page 121

HOOD ATTACHMENT POINTS, NUMBERS REFE R TO THE TEXT
Hood
Removal
1. Back off and remove the screws (1) in the door pillars.
(3 screws on each side).
2. Back off and remove the screws (2) in the wheel
houses. (1 screw on each side).
3. Back off and remove the two screws (3) at the engine
lid cover.
4. Back off and remove the two nuts (4) at the stay
attachment to the bumper
5. Back off and remove the screws (5) at the hood attach-
ment to the body frame. (1 screw on each side). Note
the rubber washers between the hood and the body
frame.
6. Rennove and pull apart the two connection pieces (6)
on both sides of the radiator.
7. Back off and remove the two screws for the headlight
control. See fig.
SCREWS, HEADLIGHT CONTROL
8. Disconnect the windshield wiper hose from the pump.
Lift the hood off forwards and upwards. Stand the
hood on its rear edge.
REMOVAL OF HOOD
SAAB
820-2
Nov. 1972