Saab SONETT III Service Manual page 64

Headlight holders
Removal
1. Take off the hood. See Chapter 8.
2. Detach the intermediate shaft by backing off and
removing the two through-going screws.
3. Remove the taper pins from the headlight shafts (three
on each headlight), thus enabling the shafts to be with-
drawn and the headlight holders to be lifted off.
If the bushings are to be renewed, the adhesive must
be ground off first.
Installation
1. F it new bushings, if necessary, attaching them with a
suitable adhesive compound, e.g. Plastic Padding.
Smear all sliding surfaces with a lubricant of the mo-
lybdenum sulphide type (Molykote).
2. R efit the headlight holders and shafts.
3. Refit the hood.
4. Align the headlights.
S 2845
HEADLIGHT HOLDER
1. Intermediate shaft
2. Taper pin
3. Bushing
4. Pullrod
5. Microswitch
6. Headlight mechanism
7. Tensioning screw
8. Headlight holder
Parking, stop and back-up lights, direction indicator lights
(flashers), number-plate light and side-position lights
General
The front park ing lights are mounted on the hood and
combined with the direction-indicator flashers. The tail
lights incorporate in the same mountings park ing lights
as weil as lamps for the stop and back-up lights, number-
plate light and direction-indicator flashers. Side-position
lights are provided on both sides at front and rear, the
bulbs for these being connected in parallel with the
parking lights. The stop-light switch is hydraulic and is
located on the secondary circuit of the master brake
cylinder. The switch for the back-up light is located on
the gear-lever housing.
Nov. 1972
SAAB
351-3