Saab SONETT III Service Manual page 74

01L-PRESSURE SWITCH
CHANGING THE 01L-PRESSURE SWITCH CHANGING THE ELECTRICAL TEMPERATURE
TRANSMITTER
Removal
Removal
1. Disconnect lead.
2. Unscrew and remove oil-pressure switch 1.06 in. (27
mm) wrench opening.
Installation
NOTE
Smear sealing compound on threads before in-
stal i ing.
1. Screw in oil-pressure switch and tighten to 12-15 Nm
(1.2-1.5 kpm, 9-10 ft.lb.).
2. Connect lead.
1. Drain off coolant.
2. Disconnect lead.
3. Unscrew transmitter 1/2 in. wrench opening.
Installation
NOTE
Smear sealing compound on threads before in-
stalling.
1. Screw in transmitter.
2. Connect lead.
3. Fill cooling system with coolant.
4. Run engine until hot and check temperature gauge
read ing.
5. Check coolant level and replenish if necessary.
TEMPERATURE TRANSMITTER
Nov. 1972
SAAB
364-3