Saab SONETT III Service Manual page 70

Windshield wiper motor, as from model 1971
3. Connect the cables on the motor. See sketch. Check
the function of the motor.
Removal
1. Remove the hood. See Chapter 8.
2. Remove the wiper arms.
3. Remove the nine self-tapping screws retain ing the
heater box cover.
4. Disconnect the electrical cables from the wiper motor.
5. Remove the clamp that is fix ing the motor to the
chassis frame. The nuts for the clamp can be reached
from the outside of the wheel housing.
6. Lift the motor and back off the nut that is fix ing the
wire tube to the motor. Tum n the motor and remove
it together with the wire.
REMOVAL OF WIPER MOTOR, AS FROM MODEL 1971
Installation
1. F it the wire of the
new wiper motor in the tube. It
might be necessary to tum n the motor and the wire
somewhat anticlockwise to get the wire to enter the
gears on the wiper spindles. Tighten the nut for the
tu be. Put the motor in place and at the same time fit
the grommet on the heater box.
2. F it the clamp for the motor. Do not forget the wooden
spacer and the rubber pad between the motor and the
wheel housing. The rubber pad should be placed at
the motor.
S 3854
CONNECTION POSITIONS OF WIPER MOTOR
4. Check that the grommet for the wire tube is correctly
fitted in the fire wall and fit the cover on the heater
box.
5. F it the wiper arms in positions where the best swept
area
is
achieved.
6. Install the engine hood as described in Chapter 8.
54T Red
53 Green alt. White
87 Blue
53 B Yellow
31 Black
SAAB
363-3
Nov. 1972