Saab SONETT III Service Manual page 127

The lid is removed by unfastening the two screws for the
hinges.
REMOVAL OF REAR WINDOW UP TO AND INCL. MODEL
1972
HINGES AND TE LESCOPICAL STAY AT REAR WINDOW,
AS FROM MODEL 1973
Replacement of opening door windows
Removal
1. Remove the door lining. See section 850.
2. Drill out the pop rivets in the rear part of the plastic
door shell and back off two of the screws retaining
the door lock so that the plastic shell can be bent to
one side.
3. Back off and remove the retaining screws for the rear
run channel and pull it out of the door.
4. Detach the door-window fastening from the U-shaped
retainer channel.
5. Pull the window glass up and lift it out.
REMOVAL OF DOOR
-
WINDOW GLASS
Installation
1. Lift the glass in and press it firmly into the retainer
channel.
2. Refit the rear run channel. Make sure that the window
moves smoothly in the run channels.
3. Rivet the plastic door shell on, using a pop-rivet tool,
and refit the screws for the door lock.
4. Ref it the door lining.
Replacement fixed glass, door
1. Remove the door. See section 830.
2. Drill out the pop rivets and rennove the plastic door
shell from the door frame.
3. Model 1970:
Drill out the pop rivets for the sealing strip. Pry off
the U-shaped retainer channei from the door frame
and the glass off from the re.-
:;(3?'
ing. Remove the
glass together with the reta; ,- iannel and sealing
strip. Collect the spacers E
en the retainer channel
and door frame.
HEMOVAL OF POP RIVETS FROM SEALING STRIP,
MODEL 1970
3. As from model 1971:
Drill out the pop rivet and remove the two nuts for
the retainer channel. These nuts are accessible from
inside the door frame.
Nov. 1972
SAAB
843-2