Jeep Cherokee 1999 Electronic Service Manual page 1371

21 - 48 TRANSMISSION AND TRANSFER CASE
DI SASSEM BLY AN D ASSEM BLY (Cont inue d)
Fig. 34 Separate Intermediate Plate and
Transmission Case
Fig. 35 Remove Intermediate Plate from
Transmission Case
(3) Align gea r t r a in a n d sh ift r a ils wit h m a t in g
h oles in t r a n sm ission ca se a n d in st a ll t r a n sm ission
ca se t o t h e in t er m edia t e pla t e (F ig. 37). Ver ify t h a t
t h e t r a n sm ission ca se is sea t ed on t h e in t er m edia t e
pla t e.
Fig. 36 Apply Sealer to Transmission Gear Case
Fig. 37 Install Transmission Gear Case to the
Intermediate Plate
(4) In st a ll n ew fr on t bea r in g sn a p r in gs (F ig. 38).
Fig. 38 Install Front Bearing Snap-rings
(5) Apply 1/8 in ch wide bea d of Th r eebon d Liqu id
Ga sket TB1281, P /N 83504038, t o t h e fr on t bea r in g
r et a in er sea lin g su r fa ce.
(6) In st a ll t h e fr on t bea r in g r et a in er (F ig. 39) a n d
t igh t en bolt s t o 17 N·m (12 ft . lbs.).
(7) On 4x2 t r a n sm ission s;
(a ) In st a ll speedom et er dr ive gea r loca t in g sn a p-
r in g (F ig. 40).
(b) In st a ll speedom et er gea r lock ba ll in ou t pu t
sh a ft a n d in st a ll speedom et er gea r on t o ou t pu t
sh a ft .
(c) In st a ll speedom et er gea r r et a in in g sn a p-r in g
on t o ou t pu t sh a ft .
X J