Jeep Cherokee 1999 Electronic Service Manual page 1288

X J
SERV I CE PROCEDU RES (Cont inue d)
Wipe filler ca p clea n , t h en ch eck t h e flu id level.
Th e dipst ick sh ou ld in dica t e COLD wh en t h e flu id is
a t n or m a l t em per a t u r e.
(1) F ill t h e pu m p flu id r eser voir t o t h e pr oper level
a n d let t h e flu id set t le for a t lea st t wo m in u t es.
(2) St a r t t h e en gin e a n d let r u n for a few secon ds
t h en t u r n en gin e off.
(3) Add flu id if n ecessa r y. Repea t t h e a bove pr oce-
du r e u n t il t h e flu id level r em a in s con st a n t a ft er r u n -
n in g t h e en gin e.
(4) Ra ise t h e fr on t wh eels off t h e gr ou n d.
(5) Slowly t u r n t h e st eer in g wh eel r igh t a n d left ,
ligh t ly con t a ct in g t h e wh eel st ops a t lea st 20 t im es.
(6) Ch eck t h e flu id level a dd if n ecessa r y.
(7) Lower t h e veh icle, st a r t t h e en gin e a n d t u r n
t h e st eer in g wh eel slowly fr om lock t o lock.
(8) St op t h e en gin e a n d ch eck t h e flu id level a n d
r efill a s r equ ir ed.
(9) If t h e flu id is ext r em ely foa m y or m ilky look-
in g, a llow t h e veh icle t o st a n d a few m in u t es a n d
r epea t t h e pr ocedu r e.
CAUTION: Do not run a vehicle with foamy fluid for
an extended period. This may cause pump damage.
REM OVAL AN D I N STALLAT I ON
POWER STEERING PUMP
NOTE: The power steering pump is mounted in the
same position on LHD and RHD vehicles. On 4.0L
RHD vehicles the front bracket is different. The ser-
vice procedures are the same.
REMOVAL
(1) Rem ove ser pen t in e dr ive belt , r efer t o Gr ou p 7
Coolin g.
(2) Rem ove pr essu r e a n d r et u r n h oses fr om pu m p,
a n d dr a in pu m p.
(3) Rem ove 3 pu m p m ou n t in g bolt s t h r ou gh pu lley
a ccess h oles .
(4) Loosen t h e 3 pu m p br a cket bolt s (F ig. 3) a n d
(F ig. 4).
(5) Tilt pu m p down wa r d a n d r em ove fr om en gin e.
(6) Rem ove pu lley fr om pu m p.
INSTALLA TION
(1) In st a ll pu lley on pu m p.
(2) In st a ll pu m p on en gin e.
(3) Tigh t en pu m p br a cket bolt s t o 47 N·m (35 ft .
lbs.).
Fig. 3 Pump Mounting
STEERING 19 - 7