Code Display System And Key Operations - Hitachi SJ700D-3 SERIES Quick Reference Manual

3.2.2 Code display system and key operations

This section describes typical examples of digital operator operation (full display mode). Refer to SJ700D-3
Instruction manual for more information.
The initial display on the monitor screen after power-on depends on the setting of function "b038". For details, see
"Initial-screen selection,"
When the setting of function "b038" is "01" (factory setting), the monitor initially shows
setting of function "d001" (output frequency monitoring). Pressing the
display to
Note: The display contents on the monitor depend on the settings of functions "b037" (function code display
restriction), "b038" (initial-screen selection), and "b039" (automatic setting of user parameters). Refer to
SJ700D-3 Instruction manual for more information.
- The following procedure enables you to turn the monitor display back to
regardless of the current display mode:
- Hold down the
- During this status, press the
which is shown when the
*) The monitor shows
running, the monitor shows an output frequency. The displayed monitor is depending on "b038" (initial-screen
selection).
.
key for 3 seconds or more. The monitor shows
FUNC
key. The monitor will show only
FUNC
is pressed.
FUNC
only when the motor driven by the inverter is stopped. While the motor is
key in this status changes the
FUNC
3 - 5
Chapter 3 Operation
as the
or
* .
or *,
*