Code Display System And Key Operations - Hitachi SJ700B SERIES Quick Reference Manual

3.2.2 Code display system and key operations

This section describes typical examples of digital operator operation (in basic and full display modes) and
an example of special digital operator operation in extended function mode U.
The initial display on the monitor screen after power-on depends on the setting of function "b038". For
details, see "Initial-screen selection,".
When the setting of function "b038" is "01" (factory setting), the monitor initially shows
the setting of function "d001" (output frequency monitoring). Pressing the
changes the display to
Note: The display contents on the monitor depend on the settings of functions "b037" (function code
display restriction), "b038" (initial-screen selection), and "b039" (automatic setting of user
parameters). For details, see, "Function code display restriction,", "Initial-screen selection,", and
"Automatic user-parameter setting,".
Item
Function code display
restriction
Initial-screen selection
(Initial display at
power-on)
Selection of automatic
user-parameter settings
*1 Not displayed with the factory setting
* The following procedure enables you to turn the monitor display back to
regardless of the current display mode:
- Hold down the
FUNC
alternately.
During this status, press the
which is shown when the
*1 The monitor shows
motor is running, the monitor shows an output frequency.
.
Function code Data
00
01
b037 02
03
04
00
01
b038
02
(*1)
03
04
05
b039 00
(*1)
01
key for 3 seconds or more. The monitor shows
key. The monitor will show only
FUNC
is pressed.
FUNC
only when the motor driven by the inverter is stopped. While the
Full display
Function-specific display
User setting
Data comparison display
Basic display (factory setting)
Screen displayed when the [STR] key was pressed last
(same as the operation on the SJ300 series)
d001 (output frequency monitoring)
d002 (output current monitoring)
d003 (rotation direction minitoring)
d007 (Scaled output frequency monitoring)
F001 (output frequency setting)
Disable
Enable
3 - 5
Chapter 3 Operation
key in this status
FUNC
Description
or
and
or
as
(*1)
(*1)
(*1),