Code Display System And Key Operations - Hitachi SJ700D-004L Instruction Manual

Chapter 3

3.2.2 Code display system and key operations

This section describes typical examples of digital operator operation (in basic and full display modes) and an example
of special digital operator operation in extended function mode U.
The initial display on the monitor screen after power-on depends on the setting of function "b038". For details,
see Section 4.2.85, "Initial-screen selection," (on page 4-78).
When the setting of function "b038" is "01" (factory setting), the monitor initially shows
setting of function "d001" (output frequency monitoring). Pressing the
display to
Note: The display contents on the monitor depend on the settings of functions "b037" (function code display
restriction), "b038" (initial-screen selection), and "b039" (automatic setting of user parameters).
For details, see Sections 4.2.84, "Function code display restriction," (on page 4-76), 4.2.85 and "Initial-screen
selection," (on page 4-78).
Function name
Function code
display restriction
Initial-screen
selection
Automatic
user-parameter
setting function
enable
note: The following procedure enables you to turn the monitor display back to
, regardless of the current display mode:
- Hold down the
FUNC
* The monitor shows
running, the monitor shows an output frequency. The displayed monitor depends on "b038" (initial-screen
selection).
.
Code
b037 00
b038 01
b039 00
key for 3 seconds or more. The monitor shows
only when the motor driven by the inverter is stopped. While the motor is
key in this status changes the
FUNC
Default
Full display
d001(Output frequency monitoring)
Disabling
3-4
Operation
as the
(*), displaying
(*) alternately.