Frequency Command Source Selection - Hitachi SJ700D-3 SERIES Quick Reference Manual

S.4.2 Frequency command source selection
Key operation to set A001
****FF3 : Change A001 from 02 (operator) to 01 (control circuit terminal block).
Procedure Key operation
1-1
1-2
1
1-3
1-4
1-5
1-6
1-7
1-8
****FEF3/FUF3 : Change from 01 (control circuit terminal block) to 02 (operator).
*) Replace the procedure 1-5 and 1-6 in the list above with 1-5' and 1-6' in the list below.
Procedure Key operation
1-5'
FUNC
1-6'
Indication
.

FUNC

2
or

FUNC

FUNC

2

STR
.
FUNC
Indication


1
Start-up
After powering up of the inverter, the operator displays 0.00,
output frequency monitor (d001)
Indication changes from data display (0.00) to parameter
display (d001).
Push the key and select the head of Group A.
Push the key and indication changes from A--- to A001.
Push the key and indication changes to 02(operator).
Push the key and change from 02 to 01 (control circuit
terminal block).
Push the key and indication changes A001 (Data save).
By pushing the key for more than three seconds,
indication changes to the output frequency data (d001).
(It depends on b038 setting)
Push the key and indication changes to 01(control circuit
terminal block).
Push the key and change the data to 02 (operator).
S - 9
Commissioning the drive
Details
Details