Hitachi SJ700D-3 SERIES Quick Reference Manual page 24

Start-up Commissioning the drive
Operating run command
(A) A001=02: Digital operator
RUN and STOP key on the digital operator allows you to start and stop the motor respectively.
RUN
RUN: STOP:
*) Changing the rotatory direction can be done by changing the parameter F004, keypad run key routing or to
exchange any two phases of the wiring to the motor. Before wiring, you should confirm that the power supply
to the inverter has been cut off.
(B) A001=01: Control terminal
You can start and stop the motor operation via the FW terminal (forward rotation) or RV terminal (Reverse
rotation).
In case of terminal FW:
Sink logic (short between P24 and PLC)
FW-CM1 short: The inverter runs the motor in the forward direction --- RUN command is active.
FW-CM1 open: The inverter decelerates and stops the motor
Source logic (short between CM1 and PLC)
FW-P24 short: The inverter runs the motor in the forward direction
FW-P24 open: The inverter decelerates and stops the motor
STOP/
RESET
Frequency
command
Motor
Speed
RUN
command
ON
--- RUN command is not active.
--- RUN command is active.
--- RUN command is not active.
Motor
speed
Time
S - 12