WAGO 750 Series Manual page 155

Vibration Velocity/Bearing Condition Monitoring VIB I/O
750-645
The Vibration Velocity/Bearing Condition Monitoring VIB I/O has a total of
12 bytes of user data in both the Input and Output Process Image (8 bytes of
module data and 4 bytes of control/status). The following table illustrates the
Input and Output Process Image, which have 8 words mapped into each
image. Word alignment is applied.
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
Input and Output Process Image
byte Destination
Offset
High Byte
0 -
1 D1
2 -
3 D3
4 -
5 D5
6 -
7 D7
Process Data Architecture for MODBUS/TCP
Low Byte
C0/S0 Not used
D0
(log. Channel 1, Sensor input 1)
C1/S1 Not used
D2
(log. Channel 2 Sensor input 2)
C2/S2 Not used
D4
(log. Channel 3 Sensor input 1)
C3/S3 Not used
D6
(log. Channel 4 Sensor input 2)
I/O Modules
Remark
Control/Status byte
(log. Channel 1,
Sensor input 1)
Data bytes
Control/Status byte
(log. Channel 2
Sensor input 2)
Data bytes
Control/Status byte
(log. Channel 3
Sensor input 1)
Data bytes
Control/Status byte
(log. Channel 4
Sensor input 2)
Data bytes
• 149