Omron NJ Series Network Connection Manual page 38

7.6.2. Checking Data That Are Sent and Received
Confirm that the correct data are sent and received.
Always confirm safety at the destination node before you transfer a user
program, configuration data, setup data, device variables, or values in memory
used for CJ-series Units from the Sysmac Studio.
The devices or machines may perform unexpected operation regardless of the
operating mode of the CPU Unit.
The Inverter will run if you proceed to this section. Confirm safety before
operation. If you cannot confirm safety, do not proceed to this section after
completing until Section 7.6.1.
If you proceed to this section, make sure to complete all the steps and place the
Inverter in the safe state.
1
Select Watch Tab Page from the
View Menu.
2
The Watch Tab Page is displayed in
the lower section of the Edit Pane.
3
The following names to monitor are
entered in the Watch Tab Page.
DN00_STA_IN[5]
DN00_STA_IN[6]
DN00_CMD_OUT[0]
DN00_DATA_OUT
4
Set the data type as follows:
DN00_STA_IN[5]:[Boolean]
DN00_STA_IN[6]:[Boolean]
DN00_CMD_OUT[0]:[Boolean]
DN00_DATA_OUT:[Decimal]
5 Confirm that the online values of
DN00_STA_IN[5] and
DN00_STA_IN[6] are True.
*DN00_STA_IN[5]:CFN
0:Follow the setting of parameter
7. Connection Procedure
35