4. Overview
This document describes the procedure for connecting the OMRON Inverter (3G3MX2 series)
to the OMRON Machine Automation NJ-series Controller (hereinafter referred to as
Controller) on the DeviceNet and provides the procedure for checking their connection.
This document describes the procedure for establishing a DeviceNet connection using
DeviceNet settings of the project files prepared in advance (hereinafter referred to as the
"procedures for using configuration files").
Sections 9 A-1 and 10 A-2 describe the procedures for setting parameters without the
prepared configuration files (hereinafter referred to as the "procedures for setting parameters
from beginning".
To follow the "procedures for using configuration files", obtain the latest "Sysmac Studio
project file" and "CX-Integrator project file" (they are referred to as "configuration files") from
OMRON in advance.
Name
Sysmac Studio project file
(extension: SMC)
CX-Integrator project file
(extension: cin)
5. Applicable Devices and Support Software
5.1. Applicable Devices
The following devices can be connected.
Manufacturer
OMRON
NJ-series CPU Unit
OMRON
DeviceNet Unit (Master Unit)
OMRON
Inverter
OMRON
DeviceNet
Unit
Additional Information
As applicable devices above, the devices listed in Section 5.2. are actually used in this
document to check the connection. When using devices not listed in Section 5.2, check the
connection by referring to the procedure in this document.
File name
OMRON_3G3MX2_DN_EV100.SMC
OMRON_3G3MX2_DN_EV100.cin
Name
NJ501-[][][][]
CJ1W-DRM21
3G3MX2-A[][][][]
Communications
3G3AX-MX2-DRT-E
4. Overview
Version
Ver.1.00
Ver.1.00
Model
Version
Versions
listed in
Section 5.2
and higher
versions
4