Omron NJ Series Network Connection Manual page 20

2
After turning ON the power
supply, the panel displays as
shown on the right.
Use the procedure on the right
to set the parameter.
[A001] Frequency Reference
Selection 1: 04
[A002] RUN Command
Selection 1: 04
*Set "04" (optional board).
*When the power supply is
turned ON, the data of d001
(Output frequency monitor) is
displayed.
(In the case of factory default
value)
00.00
Press the
a001
A001 parameter is displayed.
Press the
a002
Press the
04
Change the data to "04".
Press the
a001
The parameter is displayed again.
Press the
a002
Press the
02
The initial data is displayed.
Press the
a004
Change the data to "04".
Press the
a002
The parameter is displayed again.
7. Connection Procedure
After turning ON the power
supply, the panel displays as
shown on the left.
Mode Key 3 times.
Enter Key.
The initial data is displayed.
Increment Key twice.
Enter Key.
Increment Key once.
A002 parameter is displayed.
Enter Key.
Increment Key two times.
Enter Key.
17