Omron NJ Series Network Connection Manual page 19

7.3.2. Parameter setting
Set the parameters (node address) of the Inverter.
Additional Information
Make sure that the DeviceNet is not connected when you perform the settings.
1
Turn ON the power supply to the
Inverter.
*Set the parameters by using
the digital operator that is on
the front of the Inverter.
7. Connection Procedure
Various parameters, frequency/set
Display
value and other data are displayed
(red).
Runs the Inverter. Take note that this
RUN key
key is enabled only when the RUN
command destination is the Digital
Operator.
This key decelerates the Inverter to a
STOP/RESET
stop. (Although the STOP/RESET key is
enabled even when a RUN command is
Key
issued to a destination other than the
Digital Operator (factory default), it can
be disabled by a Setting (b087).)
If the Inverter is already tripped, the trip
will be reset (return from the tripping).
Parameter is displayed: Move to the
Mode key
beginning of the next function group.
Data is displayed: Cancel the setting
and return to the parameter display.
Individual input mode: Move the blinking
digit to the left.
Regardless of the displayed screen,
pressing and holding this key (for 1
second or more) displays the data for
Output Frequency Monitor (d001).
These keys are used to
Increment key
increment/decrement a parameter or set
data. Pressing and holding each key
Decrement key
increases the
incrementing/decrementing speed.
Pressing the Increment and Decrement
keys together activates the "Individual
Input MODE" where each digit can be
edited independently.
Parameter is displayed: Move to the
Enter key
data display.
Data is displayed: Confirm/store the
setting (in the EEPROM) and return to
the parameter display.
Individual input mode: Move the blinking
digit to the right.
16