This manual covers different models. The oven you have purchased may have some or all of the items listed. The locations and
appearances of the items shown here may not match those of your model.
A. Oven display symbol
B. Heat settings
C. Oven display
D. Start/stop time
E. Number pads
F. Control lock
When power is first supplied to the oven, everything on the
display will light up for 5 seconds. Then, "PF" will appear on the
oven display and a time of day will appear on the Time of Day
display. Press CANCEL/OFF to clear the oven display.
If "PF" appears at any other time, a power failure has occurred.
Press CANCEL/OFF and reset the clock if needed.
When the oven is in use, this display shows the oven
temperature, heat source and start time.
In addition, during Timed Cooking, this display shows a vertical
bar and time countdown and the stop time (if entered).
If "Err" appears on the oven display, an invalid pad was pressed.
Press CANCEL/OFF and retry your entry.
When the ovens are not in use, this display is blank.
Time of Day, Timer Display
This display shows the time of day or Timer countdown.
The START pad begins all oven functions except the Timer,
Control Lock and Sabbath Mode. If not pressed within 5 seconds
after pressing a pad, "START?" will appear on the oven display as
a reminder. If not pressed within 4 or 5 minutes after pressing a
pad, the oven display will return to inactive mode (blank) and the
programmed function will be canceled.
The CANCEL/OFF pad stops the oven functions except for the
Clock, Timer, Control Lock and Sabbath Mode. The cooling fan
may continue to operate even after an oven function has been
canceled, depending on the oven temperature.
All manuals and user guides at all-guides.com
ELECTRONIC OVEN CONTROL
G. Time of day/timer display
I. Oven settings
J. EasyConvect™ conversion
K. Timed cooking
This is a 12-hour clock and does not show a.m. or p.m.
Before setting, make sure the oven, Timer and Timed Cooking
1. Touch CLOCK SET/START.
2. Touch the number keys to set the time of day.
3. Touch CLOCK SET/START again.
To Remove/Return Time of Day from Display: Press and hold
CLOCK SET/START for 5 seconds. Repeat to redisplay. The time
should not have to be reset.
Tones are audible signals, indicating the following:
Valid pad press
Oven is preheated
Function has been entered
Invalid pad press
End of cycle
Reminder, repeating each minute after the end-of-cycle tones
L. Convect full meal
M. Oven light
O. Minute timer
P. Surface light