A.
All springs must be compressed until they
measure 3.96 cm (1.56 inches).
B.
Use the jam nut to compress any spring
that measure greater than 3.96 cm (1.56
inches).
Figure 4
1. Section-hinge spring
2. Jam nut
4.
Repeat the procedure for each spring on both
section hinges.
5.
Move the sections into the transport 'X' position.
See
Using the Boom-Transport Cradle (page
29)
for more information.
g035648
3. Compressed spring
dimension—3.96 cm (1.56
inches)
3
Learning More about Your
Product
Parts needed for this procedure:
1
Ignition key
1
Operator's Manual
1
Engine operator's manual
1
Parts Catalog
1
Operator training material
1
Registration card
1
Pre-delivery Inspection Sheet
Procedure
1.
Read the manuals.
2.
View the operator training material.
3.
Complete the registration card and return it to
Toro.
4.
Store the documentation in a safe place.
15