Maintenance; Recommended Maintenance Schedule(S) - Toro Multi Pro 1750 Operator's Manual

Maintenance

Note:
Download a free copy of the schematic by visiting www.Toro.com and searching for your machine
from the Manuals link on the home page.
For additional information about the sprayer system, refer to the sprayer system schematic in
(page 72).
Note:
Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
After the first 100 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Maintenance Procedure
• Torque the wheel-lug nuts.
• Replace the hydraulic filter.
• Change the engine oil.
• Check the air filter for the carbon canister.
• Replace the carbon-canister filter.
• To provide proper performance and long sprayer life, follow these guidelines for
the first 100 operating hours:
• Clean the suction filter.
• Clean the pressure filter.
• Check the tank straps.
• Check the engine-rotating screen.
• Check the engine oil.
• Check the tire pressure.
• Lubricate the pump.
• Clean and oil the air-cleaner foam element (more often in dusty, dirty conditions).
• Check the battery-cable connections.
• Check the battery-electrolyte level.
• Lubricate all grease fittings.
• Lubricate the section hinges.
• Clean the engine-rotating screen (more often in dusty, dirty conditions).
• Change the engine oil (more often when operating under heavy load or in high
temperature).
• Replace the engine-oil filter.
• Replace the fuel filter.
• Torque the wheel-lug nuts.
• Inspect the condition and wear of the tires.
• Check front wheel toe-in.
• Inspect the brakes.
• Replace the air-cleaner paper element (more often in dusty, dirty conditions).
• Change the spark plugs.
• Check the air filter for the carbon canister.
• Replace the carbon-canister filter.
• Check the adjustment of the differential-lock cable.
• Check the parking brake.
• Check the transaxle/hydraulic fluid.
• Inspect all hoses and connections for damage and proper attachment.
• Clean the flow meter (more often when using wettable powders).
37
Schematics