Electrical System Maintenance; Locating The Fuses; Servicing The Battery - Toro Multi Pro 1750 Operator's Manual

Electrical System
Maintenance

Locating the Fuses

There are 2 fuse blocks and 1 empty slot in the
electrical system. They are located beneath the seat
(Figure 43).
Figure 43
1. Battery

Servicing the Battery

WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm. Wash
hands after handling.
Important:
Do not jump start the sprayer.
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery and battery box. If
the battery terminals are corroded, clean them with
a solution of 4 parts water and 1 part baking soda.
Apply a light coating of grease to the battery terminals
to prevent corrosion.
Voltage: 12 V with 280 cold cranking A at 0°F
Removing the Battery
1. Position the sprayer on a level surface, engage
the parking brake, shut off the sprayer pump,
shut off the engine, and remove the key.
g023046
2. Fuse blocks
2. The battery is located on the right side of the
machine behind the pump
3. Disconnect the negative (black) ground cable
from the battery post.
WARNING
Incorrect battery-cable routing could
damage the sprayer and cables causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
WARNING
Battery terminals or metal tools could
short against metal sprayer components
causing sparks. Sparks can cause the
battery gasses to explode, resulting in
personal injury.
• When removing or installing the
battery, do not allow the battery
terminals to touch any metal parts of
the sprayer.
• Do not allow metal tools to short
between the battery terminals and
metal parts of the sprayer.
• Always keep the battery strap in place
to protect and secure the battery.
4. Disconnect the positive (red) cable from the
battery post.
5. Remove the battery retainer and fasteners
(Figure 43).
6. Remove the battery.
Installing the Battery
Service Interval: Every 50 hours—Check the
battery-cable connections.
1. Set the battery on the battery box so that the
battery posts are toward the front of the sprayer.
2. Install the battery retainer and secure it with the
fasteners you removed previously
47
(Figure 43).
(Figure 43).