pressure reading on the gauge is 6.9 bar (100
psi).
Figure 20
1. Agitation-bypass valve
12.
Press the pump switch to the O
the throttle lever to the I
the ignition switch to the O
Adjusting the
Master-Section-Bypass
Valve
Note:
Adjusting the master-section-bypass valve
reduces or increases the amount of flow sent to the
agitation nozzles in the tank when the master-section
switch is set to the O
FF
1.
Fill the sprayer tank 1/2 full with clean water.
2.
Move the machine to an open level surface.
3.
Set the parking brake.
4.
Set the range selector to the N
5.
Set the pump switch to the O
6.
Set the agitation switch to the O
7.
Set the master-section switch to the O
position.
8.
Increase the engine speed to full throttle and set
the throttle lock to the O
9.
Adjust the master-section-bypass handle to
control the amount of agitation occurring in the
tank
(Figure
20).
10.
Reduce the throttle speed to idle.
11.
Set the agitation switch and pump switch to the
O
position.
FF
12.
Shut off the machine.
2. Master-section bypass
position, shift
FF
position, and turn
DLE
position.
FF
position.
position.
EUTRAL
position.
N
position.
N
FF
position.
N
Locating the Spray Pump
The spray pump is located under the seat
g028049
Hauling the Machine
•
Use full-width ramps for loading the machine onto
a trailer or truck.
•
Tie the machine down securely.
Transporting the Sprayer
When moving the sprayer long distances, use a trailer.
•
Secure the sprayer to the trailer.
– Use the tie-down loop at the front of the frame;
refer to
– Use the 2 tie-down loops at the rear of the
frame; refer to
•
Ensure that the outer-boom sections are tied down
and secure.
33
Figure 21
Figure
22A.
Figure
22B.
(Figure
21).
g216323