Tektronix P5210 Instructions Manual page 21

Table 3: Certifications and Compliances
EC Declaration of Compliance was demonstrated to the following specification as
Conformity – Low listed in the Official Journal of the European Communities:
Voltage
Low Voltage Directive 73/23/EEC, as amended by 93/68/EEC:
EN 61010-1/A2:1995
EN 61010-2-031:1994
Approvals UL3111-1 – Standard for electrical measuring and test equipment
IEC 1010-2-031 – Particular requirements for hand-held probe
assemblies for electrical measurement and test
CAN/CSA-C22.2 No. 1010.1-92 and CAN/CSA-C22.2 No.
1010.2.031-94 – Safety requirements for electrical equipment for
measurement, control, and laboratory use
Installation Category Terminals on this product may have different installation category
Descriptions designations. The installation categories are:
CAT III
CAT II
CAT I
Pollution Degree 2 Do not operate in environments where conductive pollutants may
be present.
P5210 Instructions
Safety requirements for electrical equipment for
measurement, control, and laboratory use
Particular requirements for hand-held probe assemblies for
electrical measurement and test equipment
Distribution-level mains (usually permanently
connected). Equipment at this level is typically
in a fixed industrial location
Local-level mains (wall sockets). Equipment at
this level includes appliances, portable tools,
and similar products. Equipment is usually
cord-connected
Secondary (signal level) or battery operated
circuits of electronic equipment
Specifications
19