General Safety Summary - Tektronix P5210 Instructions Manual

General Safety Summary

Review the following safety precautions to avoid injury and prevent
damage to this product or any products connected to it.
Injury Precautions
Avoid Electric Overload.
potential to any input, including the common inputs, that varies from
ground by more than the maximum rating for that input.
Avoid Electric Shock.
output to a measurement instrument before connecting the test leads
to a voltage source. Do not disconnect the probe from the measure-
ment instrument while the test leads are connected to a voltage
source. Use only probe accessories that are rated for the application.
Avoid RF Burns While Handling Probe.
handle the probe while the input leads are connected to circuits
above the voltage and frequency limits specified in Figure 2 on page
13. Use only probe accessories that are rated for the application.
Do Not Operate Without Covers.
do not operate this product with covers or panels removed.
Do Not Operate in Wet/Damp Conditions.
operate this product in wet or damp conditions.
Do Not Operate in an Explosive Atmosphere.
hazard, do not operate this product in an explosive atmosphere.
Keep Probe Surface Clean and Dry.
erroneous readings, keep probe surface clean and dry.
Product Damage Precautions
Do Not Operate With Suspected Failures.
to this product, have it inspected by qualified service personnel.
Do Not Immerse in Liquids.
Refer to the cleaning instructions on page 16.
2
To avoid injury or fire hazard, do not apply
To avoid injury or loss of life, connect the probe
To avoid RF burns, do not
To avoid electric shock or fire hazard,
To avoid electric shock, do not
To avoid injury or fire
To avoid electric shock and
If you suspect there is damage
Clean the probe using only a damp cloth.
P5210 Instructions