Set The Printer Address - IBM 3197 C User Manual

(-
Set the Printer Address
This function defines the address for the pr,inter that is attached to the display
station.
Note: You need the setting of the printer address because you selected
display-printer mode in the terminal mode selection (refer to the procedure for
specifying the terminal mode).
1. Set the power switch to 0 (off).
2. Press and hold the space bar and set the power switch to
I
(on). Hold the
space bar until the test pattern appears.
3. Press the SetUp key. A diamond
«»
appears on the operating status line.
4. Press and release the Terminal Mode (Cmd20) key until"
the left of the keyboard ID symbol "--".
<.>
" appears at
2 - -
LKeYbOard 10
'----Terminal Mode
5. The printer address of the printer attached to the display station is displayed
on the operating status line. If you press and hold the Cmd24 key, the
printer address increases. When the address reaches 6, the sequence
starts over again from O.
Chapter' 3. USing the 122-key Keyboard
3-13