Set Station Address 1 - IBM 3197 C User Manual

Set Station Address 1
This function defines the address of your display station 1.
1. Set the power switch to 0 (off).
2. Press and hold the space bar and set the power switch to
I
(on). Hold the
space bar until the test pattern appears.
3. Press the SetUp key. A diamond
«> )
appears on the operating status line.
4. The station address of your display station 1 is displayed at the right side of
the operating status line. If you press and hold the Cmd23 key, station
address 1 increases. When the address reaches 6, the sequence starts over
again from O.
1
CH]
2 - -
Terminal Mode (Example)
Station Address 1 (Example)
5. Release the Cmd23 key when your desired address of station address 1
appears on the operating status line.
6. Press the SetUp key. The diamond disappears as you exit from setup mode.
Once selected, station address 1 will be stored and will not be reset when
the display station power switch is set to 0 (off).
7. Press the Reset key to enter normal communication mode.
3-10
IBM 3197 User's Guide
o
C · · "' ,
J~
;