Table of Contents
Advertisement
. -
..
--------~--~.-~~----~----~~~~~--~~~~~-
~~~~~~--~--~--.-----
...
- - - -
Set Station Address 1
~
.. u.
Ano
I
\
This function defines the address of your display station.
~ "I
'"
I
\
1.
Set the power switch to 0 (off).
2.
Press and hold the space bar and set the power switch to
I
(on). Hold the
space bar until the test pattern appears.
3.
Press and hold the Shift key and then pr.ess the SetUp key. A diamond
«»
appears on the operating status line.
4.
The station address of your display station 1 will be displayed in the
operating status line. If you press and hold the F23/F11 key while pressing
and holding the Shift key, station address 1 increases. When the address
reaches 6, the sequence starts over again from
O.
Terminal Mode (Example)
Station Address 1 (Example)
5.
Release both the F23/Fl1 key and the Shift key when your desired address
of station address 1 appetlrs on the screen.
6.
Press and hold the Shift key and then press the SetUp key. The diamond
disappears as you exit from the setup mode. Once selected, the station
address will be stored and will not be reset when the display station power
switch is set to 0 (off).
7.
Press the Reset key to enter normal communication mode.
5-10
IBM 3197 User's Guide
c:
Advertisement
Table of Contents
