Table of Contents
Advertisement
(--
Specifying Character Pitch
I
1.
Press and hold the Alt key and then press the PrtSet (F13/F1) key to enter
online printer setup mode. Check that the following symbols are displayed
on the operating status line.
(:'
. •
Printer Setup Mode Symbol
Character Pitch (CPI)
2.
Press and hold the Shift key and then press the F16/F4 key. Each time you
press the F16/F4 key while holding down the Shift key, the character pitch
selection symbol will change in the following order.
Note: The selection of the character pitch selections is limited when you.
select the 5256 device ID. See Figure 5-1, "Selection of Print Functions" for
additional information.
3.
If you want to exit from online printer setup mode, press and hold the Alt key
and then press the PrtSet (F13/F1) key.
If you need to specify the line pitch and the character quality, go to the next
section.
Chapter 5. Using the IBM Enhanced Keyboard
5-41
Advertisement
Table of Contents
