Table of Contents
Advertisement
(
(
(
Display Dim Interval Adjustment
~
.,",
An"
I
\
Note: When display dim is enabled (
is displayed), the screen will blank,
except for the operating status line if no key is pressed and no data is received
from the host system for the specified time (0, 2, 5, 10 and 20 minutes).
I
1.
Press and hold the Shift key, and press the SetUp key. A diamond ( ) and
the Display Dim Indicator ( ) appear on the operating status line.
Display Dim Interval (0, 2, 5, 10, 20 minutes)
~--
Dim Indicator
2.
Press and release the F15/F3 key until the desired time among 5 selections
(0, 2, 5, 10 and 20 minutes) appears on the operating status line.
3.
Press and hold the Shift key and press the SetUp key. The diamond
disappears as you exit from setup mode. Once selected, the auto display
dim will be stored and will not be reset when the display station power
switch is set to 0 (off).
Chapter 5. Using the IBM Enhanced Keyboard
5-17
Advertisement
Table of Contents
