Specifying Character Pitch
3-38
1.
Press and hold the Alt key and press the SetUp key to enter online printer
setup mode. Check that the following symbols are displayed on the
operating status line .
. .
Printer Setup Mode Symbol
Character Pitch (CPI)
2.
Press and release the Cmd16 key. Each time you press the Cmd16 key, the
character pitch selection symbol will change in the following order.
[AA
1
O-AA
12 -
HAl
7
-AA~
-AA
~ -AAS - AA
6 -AA8.5
J
Note: The selection of the character pitch is limited when you select the
5256 Device 10. See Figure 3-1, for additional information.
3.
If you want to exit from online printer setup mode, press and hold the Alt key
and then press the SetUp key.
c
If you need to specify the line pitch and the character quality, go to the next
0 \
- "\,
section.
.
IBM 3197 User's Guide