Table of Contents
Advertisement
Enable/Disable Clicker Action
1.
Press and hold the Shift key, and press the SetUp key. A diamond
«»
and
the clicker symbol appear on the operating status line.
Clicker Volume
'----Clicker Symbol
2.
Press the F18/F6 key to alternately enable or disable the clicker.
Note: When you press the F18/F6 key: if you hear a click, clicker action is
enabled; if you do not hear a click, clicker action is disabled.
3.
Press and hold the Shift key, and press the SetUp key again. The diamond
disappears as you exit from setup mode. Once selected, the clicker action
will be stored and will not be reset when the display station power switch is
set to
a
(off).
5-20
IBM 3197 User's Guide
c
/
Advertisement
Table of Contents
