Table of Contents
Advertisement
Display-Printer Mode Selection
1.
Set the power switch to 0 (off).
2.
Press and hold the space bar and set the power switch to
I
(on). Hold the
space bar until the test pattern appears.
3.
Press the SetUp key. A diamond (» appears on the operating status line.
4.
Locate the symbol of the terminal mode at the right side of the operating
status line. That symbol should be one of the following symbols
( () ,
and
).
l . . .
< _ > _
_
--+-,,-;.,_)
'.~
• .'
i,_)
=r=:
l
Terminal Mode
(Example)
5.
If the symbol of terminal mode is other than
, press and release the
Cmd20 key until
appears at the position of the operating status line;
then release the Cmd20 key. If the symbol is
, go to the next step.
6.
Press the SetUp key. The diamond disappears as you exit from setup mode.
You have now selected and recorded display-printer mode.
Continue to the next offline printer setup mode operation.
Chapter 3. Using the 122-key Keyboard
3-35
Advertisement
Table of Contents
