Table of Contents
Advertisement
Set Station Address 2
~
""'
Ano
I
\
(
This function defines the address of your display station 2.
Note: You need the setting of station address 2 because you selected
two-display mode in the terminal mode selection (refer to the procedure for
specifying the terminal mode).
1.
Set the power switch to 0 (off).
2.
Press and hold the space bar and set the power switch to
I
(on). Hold the
space bar until the test pattern appears.
3.
Press and hold the Shift key and then press the SetUp key.
A diamond (
) appears on the operating status line.
4.
The station address of your display station 2 is displayed at the right of
Terminal Mode Symbol on the operating status line. If you press and hold
the F24/F12 key while pressing and holding the Shift key, station address 2
increases. When the address reaches 6, the sequence starts over again
froll) O.
~--Station
Address 1 (Example)
Chapter 5. Using the IBM Enhanced Keyboard
5-11
Advertisement
Table of Contents
