Setting The Address, Ce, And Terminator Switches - IBM 5291 Setup Procedure

18
SETTING THE ADDRESS, CE, AND TERMINATOR SWITCHES
Set the switches by doing the following six steps.
I
I
--
1. Get the address from the floor plan, .from the label attached
to the cable, or ask your planner. The address for the display
station that you are setting up is a number (0 through 6).
Note: The address for each work station must be different when work
stations. are connected together. If the address has not been determined,
information on how to determine this address can be found in the
following guides:
• For local work station addresses, see the host system planning and
installation
I
modification guides.
• For remote work station addresses, see the /BM 5250 Planning and Site
Preparation Guide, GA21-9337.