Table of Contents
Advertisement
Error
Cause
Recovery Action
Code
0015
You entered data into a self-check field.
Press the Reset key.
The number and the check digit you just
Check that you have correctly entered the
entered do not correspond.
number and check digit. If you have
entered them correctly, check that the
number is valid for a self-check field. If
the numbers are valid but this error still
occurs, report the problem to your system
operator.
0016
You pressed the Fielci - key, but the field
Press the Reset key.
you were in is not a signed numeric field
Continue to enter data or press the Field
or, for some systems, a numeric-only field.
Exit key to blank out all of the field.
0017
You pressed the Field -, Field
+,
or Field
Press the Reset key.
Exit key. However, the requirements for
Enter data to the end of the field, or move
this mandatory-fill field have not been
the cursor to the start of the field and use
met.
the Field -, Field
+ ,
or Field Exit key to
A mandatory-fill field must be filled
blank out all of the field.
completely or you must exit from the first
position of the field.
0018
You must use a non-data key, such as the
Press the Reset key.
Field Exit key or a cursor movement key,
Use a non-data key to leave this field.
to leave this field.
0019
You pressed the Dup key, which is not
Press the Reset key.
I
permitted in this field.
Continue, but without using the Dup key in
this field.
0020
You pressed a key that is not allowed in
Press the Reset key.
this field.
The cursor is in the same position as
This is either a right-adjust or a signed
when you pressed the invalid key.
numeric field. You must exit the field
Continue by pressing the Field
+,
Field -,
before pressing any of the following:
or Field Exit key.
Command/Function keys, Character
Backspace key, Enter key, Print key, Help
key, Roll keys, and the Home key (when
the cursor is in the home position).
0021
The cursor is positioned in a
Press the Reset key.
mandatory-enter field. A mandatory-enter
Enter the required data.
field must have data entered in it before
you can exit the field by pressing the
Field
+,
Field -, or Field Exit key.
0022
A system error occurred.
Press the Reset key.
The status of the present field is not
Check the display to determine if the
known. This error can occur during an
insert or delete function was done
insert or delete operation.
properly.
If not done properly, correct the field.
0023
You pressed the Hex key but the first key
Press the Reset key.
pressed was not a character A through F
Continue by using the correct keys.
or 4 through 9; or the second key pressed
was not a character A through For 0
through 9. This error also occurs when a
hexadecimal code is used in a
numeric-only, signed numeric, alpha-only,
or feature I/O field.
Appendix A. Error Codes and Recovery Procedures
A-3
Advertisement
Table of Contents
