Select The Terminal Mode - IBM 3197 C User Manual

Select the Terminal Mode
Note: The selection of the terminal mode should be made based on your
terminal configuration. Consult your supervisor or system operator before
starting this procedure.
1. Set the power switch to 0 (off).
2. Press and hold the space bar and set the power switch to
I
(on).
Hold the space bar until the test pattern appears.
3. Press the SetUp key. A diamond
«1
and one of the following terminal mode
symbols appear on the operating status line.
3-4
IBM 3197 User's Guide
LJ .•••
One-Display Mode
.... Two-Display Mode
.... Display-Printer Mode
The symbols on the operating status line are shown as follows:
Setup Mode Symbol Terminal Mode
(Example)