Invacare® TDX® SP2 Series
Inspect battery terminals for loose cable
connection. Tighten if necessary.
Ensure swingarm stops are in place and not
deteriorated or damaged. Replace if necessary.
Clean upholstery and armrests.
Clean dirt and lint from axles.
Clean dirt and lint from bearings.
Check that all labels are present and legible.
Replace if necessary.
Ensure clothing guards are secure.
Ensure upholstery does not have any rips
or tears.
Ensure armrest pad sits flush against arm tube.
Ensure wheelchair rolls straight (no excessive
drag or pull to one side).
Ensure that the casters are free of debris.
Inspect all fasteners including the back pan,
back cane and angle adjustment fasteners, and
the arm support, flip back and height
adjustment fasteners. Ensure fasteners are
securely tightened. Refer to the seating system
service manual for torque specifications and
tightening instructions.
Inspect TRBKTS fasteners and hardware.
Inspect foam handgrips for damage. If
damaged, have them replaced by a qualified
technician.
10.3.2 Replace Every 18 Months
Replace gearbox coupling.
10.3.3 Replace Every 2 Years
The stability locking cylinder MUST be replaced
every two years.
10.4 Removing/Installing the Shrouds
CAUTION!
-Place the wheelchair in a well-ventilated area
where work can be performed without risking
damage to carpeting or floor covering.
43
10.4.1 Removing/Installing the Rear Shroud
Fig. 10-1
Removing the Rear Shroud
1. Verify the joystick On/Off switch is in
the Off position.
2. Remove the knob screw A that secures the
rear shroud B to the base frame C.
3. Remove the rear shroud from the base frame.
Installing the Rear Shroud
1. Install the rear shroud B and secure in place
with knob screw A.
10.4.2 Removing/Installing the Front Shroud
Fig. 10-2 Removing the Front Shroud
60101831-I