Mitsubishi Electric AE-200A Instruction Book page 8

(2) When controlling more than 50 units of equipment
electricity billing function
HUB
Setting PC *2
HUB *1
LAN1
LAN1
*1 Use a switching HUB to connect to LAN1 and LAN2 (BACnet
*2 A PC (hereafter referred to as Setting PC) is required to make settings for the AE-200/AE-50/EW-50 BACnet
settings, disconnect the Setting PC from the AE-200/AE-50/EW-50. Refer to section 7 "Checking installation operations and performing
trial run" for details.
*3 Up to 50 units of equipment can be connected to and controlled by each AE-200/AE-50/EW-50. If performing centralized control with an
AE-200, up to 3 AE-50/EW-50 can be connected to a single AE-200 (if not using AE-200 M-NET, up to 4 can be connected).
*4 If performing centralized control with an AE-200, because time synchronization from the building management system comes through
the AE-200, then for systems including those that do not have BACnet
®
BACnet , by connecting devices to control with BACnet
WT07919X04
HUB *1
BACnet
*1
LAN2
LAN1
M-NET
AE-200 /EW-50
*4
Outdoor
unit
Outdoor
unit
LAN2
LAN1
M-NET
AE-50/EW-50
Outdoor
unit
Outdoor
unit
LAN2
M-NET
Outdoor unit/indoor unit etc.
AE-50/EW-50
LAN2
M-NET
Outdoor unit/indoor unit etc.
AE-50/EW-50
and not using an apportioned
*3
Building management system
HUB *1
®
M-NET
Indoor unit
ME remote controller
M-NET
Indoor unit
ME remote controller
M-NET
Indoor unit
ME remote controller
M-NET
Indoor unit
ME remote controller
®
). Do not connect LAN1 and LAN2 (BACnet
®
control functions, configure so that AE-200 is connected to the
®
to the AE-200.
8
LOSSNAY
LOSSNAY
LOSSNAY
LOSSNAY
®
) to the same HUB.
®
functions. After making