1.0 - INTRODUCTORY NOTE TABLE OF CONTENTS Dear customer, thank you for choosing this GEMINI product designed and manufactured in Italy - INTRODUCTORY NOTE.................... PAGE 03 specifically for recreational vehicles. - REMOTE CONTROL 738W AND BATTERY REPLACEMENT........PAGE 03 This new generation 93 MHW CAN BUS alarm system has been implemented with a 2.45GHz USER MANUAL transceiver and ZigBee wireless technology with anti-jamming reliability.
If an alarm event has occurred while you were away from your vehicle, it will be signaled, when you To arm the system without arming interior protection press button “3” on the Gemini remote control. disarm the sytem, by 5 siren chirps and 5 flashes of the turn indicators.
ON during an alarm wiring diagram. condition (See available diagrams in the restricted area of our website: www.gemini-alarm.com ORANGE wires turn indicator flashes for all optical signaling functions (factory enabled). PAGE 06 - INSTALLER MANUAL INSTALLER MANUAL - PAGE 07...
7.0 - CONNECTIONS TO ARM/DISARM THE SYSTEM In either case, repeat the whole procedure. Alarm system 93 MHW can work either via CAN BUS or via the Gemini remote control (P/N 738W) as described hereunder. Connect the wiring harness connectors to the corresponding alarm connectors.
8.0 - SYSTEM PROGRAMMING The table below applies to the system programmed in “standard configuration”. Press Gemini remote control button “ON” to enable a programmable function and Every time you enter in programming mode, the alarm system resets to the default settings.
10.0 - LEARNING NEW DEVICES 11.0 - DELETING PROGRAMMED DEVICES To carry out the operation successfully, make sure the required electrical connections To carry out the operation successfully, make sure the required electrical connections (bonnet switch and ignition) are properly connected. (bonnet switch and ignition) are properly connected.
12.0 - ULTRASONIC VOLUMETRIC PROTECTION 14.0 - TECHNICAL SPECIFICATIONS 12.1 - CONNECTIONS AND POSITIONING Power supply 12Vdc Insert the WHITE connector in the “W” marked socket. Current draw (system armed and LED flashing) 15mA @ 12Vdc Insert the RED connector in the “R” marked socket. Operating temperature range -30°C =>...