Table of Contents
Advertisement
I
TABLE OF CONTENTS
1.0
2.0
2.1 - Complete system arming
3.0
3.1
3.2
3.3
4.0
4.2 - 8-pin connector
5.0
6.0
7.0
8.0
8.6 -
9.0
10.0
-
ADDING NEW DEVICES
11.0
12
.0
13.0
- SYSTEM RESET
14.0
- TECHNICAL SPECIFICATIONS
15.0
-
PAGE 02
1.0 - INTRODUCTORY NOTE
Dear Customer, thank you for choosing a Gemini alarm system.
This product, supplied with 1 touch key to emergency override the system and exclude the sensors,
can also be managed by the following Gemini optional devices:
• an RFID transponder (908)
• a 2-button remote control (7208E)
• a 4-button remote control 848/ALG
Please read the present manual carefully to familiarize yourself fully with the operation of your alarm
system and pay special attention to the following signs:
.
This sign highlights useful information.
This sign indicates that the system will operate according to the connections and the
!
selected configuration or it simply provides helpuf information on installing the alarm
2.0 - OPERATING INSTRUCTIONS
2.1 - SYSTEM TOTAL ARMING
Press the vehicle original remote control lock button or button "1" on a Gemini remote control. If the
optical/acoustic signals have been enabled, arming will be confirmed by 1 flash of the turn indicators
and 1 Beep.
The system has a 30 sec. arming delay signaled by the LED turned ON steady.
When the system is fully armed, after the arming delay, the LED will blink according to the associated
devices (ex. if the alarm system works with 1 touch key and 1 remote control, the flashing sequence,
while the alarm is armed, will be the following: 2 quick flashes in a row followed by a pause.).
2.2 - SYSTEM ARMING WITH SENSOR EXCLUSION
The system can be armed without enabling the internal volumetric protection (ultrasonic sensors) and
optional wireless PIR sensors
.
To arm the system and exclude the sensors proceed as follows:
• Touch the key to its receptacle; the LED will give off a quick flash.
• Close all doors and press the original remote control lock button
7208E.
NB:
With remote control 848/ALG, simply press button "3" without touching the override key to its
receptacle.
• Arming will be confirmed by optical/acoustic signals (if enabled).
Sensor exclusion is bound to each single arming cycle.
For the user.
For the installer.
system.
USER GUIDE
or button "1" on remote control
PAGE 03
Advertisement
Table of Contents
