Programmable Features - Gemini 953 Installation And Use Manual

14.0 - PROGRAMMABLE FEATURES

To either enable or disable one of the programmable features proceed as
illustrated below:
NB: Remember to ALWAYS arm and disarm the alarm before programming.
1
With the alarm system disarmed, lift the
seat or open the topcase. If there is no
2
Turn ignition key ON.
3
The LED will light up for approx. 1".
4
While the LED is ON, simultaneously press
the 2 buttons on the remote control.
T wo beeps (low and high) will confirm the
system is in programming mode. The LED
Page 29
contact switch, ground the
GREEN/BROWN wire.
Remove from ground after
programming.
will light up steady .
After pressing both buttons simultaneously (step 4), program the features
according to your needs.
TO ENABL E
Press button 1
Button N.1: ENABLE
ACOUSTIC SIGNALS
(factory enabled)
Button N.2: DISABLE
Button N.1: ENABLE
PANIC SIREN
(factory enabled)
Button N.2: DISABLE
Button N.1: ENABLE
SHOCK SENSOR
(factory enabled)
Button N.2: DISABLE
Button N.1: ENABLE
PASSIVE ARMING
(factory disabled)
Button N.2: DISABLE
Button N.1: ENABLE
ANTI-HIJACK
(factory disabled)
Button N.2: DISABLE
Button N.1: ENABLE
PRE-ALARM
(factory disabled)
Button N.2: DISABLE
Button N.1: ENABLE
SELF-REARMING
(factory disabled)
Button N.2: DISABLE
TO DISABL E
Press button 2
EXIT PROGRAMMING
Page 30