Optical/Acoustic Signals; Panic Alarm Via Remote Control; Shock Sensor; Passive Arming - Gemini 953 Installation And Use Manual

Table of Contents

Advertisement

5.1 - OPTICAL/ACOUSTIC
Optical signals (turn indicators and status LED) and acoustic signals (siren)
indicate arming/disarming, alarm memory, system programming and learning
of new devices. Acoustic signals can be disabled.
5

.2 - PANIC ALARM VIA REMOTE CONTROL

For use in emergency situations. Panic alarms can be triggered as many times
as necessary but at least 5" must elapse between two consecutive alarms.
Pressing button 2 will immediately activate the siren and the turn indicators for
approx. 30 seconds. To turn off the panic siren simply press button 2 again. The
panic siren can be activated with either an armed or disarmed system.

5.3 - SHOCK SENSOR

The built-in sensor triggers an alarm whenever it detects tilt, motion or a
sudden shock to the vehicle. Sensitivity is adjustable.

5.4 - PASSIVE ARMING

The system can be programmed to automatically arm every time ignition is
turned OFF, making sure the vehicle will not be left unprotected.
When ignition is turned OFF the turn indicators flash once, the status LED twice
and the siren chirps 2 times to signal the passive arming countdown.
The system fully arms (passive arming) 35" after ignition is turned OFF. A flash
of the turn indicators and 2 beeps will confirm the system is armed. The LED
will turn ON steady.
Lifting the seat or opening the topcase (if protected by a contact switch) during
the 35" arming delay will cause the procedure to interrupt; it will resume once
the seat/topcase is closed.
To interrupt passive arming, turn ignition ON within 35" of turning it OFF.

5.5 - ANTI-HIJACK FEATURE

This feature allows the user to remotely switch off the motorcycle engine in
case of a hijack attempt.
To activate the anti-hijack while the engine is running, either:
!
Press remote control button1, or
!
Press remote control button 2, or
!
Insert the electronic key in its receptacle
Two quick flashes of the turn indicators will confirm activation and the LED will
turn ON steady.
CAUTION
When the anti-hijack feature is activated, the remote controls become
inoperative.
Page 7
SIGNALS
.
The system will kill the motorcycle engine 20" after the anti-hijack feature is
actived. Two seconds later the siren will go off for 1 minute while the turn
indicators will blink repeatedly until the anti-hijack is deactivated.
To deativate the anti-hijack alarm insert the electronic key in its receptacle
5.6 - PRE-ALARM
During an alarm condition, the siren will only go off for 2.5 seconds (rather than
for the standard 30 sec.). The pre-alarm mode is only activated for the
alarm events, from the 4th detection, the siren will sound for the full 30 sec.
sequence.
The pre-alarm feature helps preserve battery life and reduce noise
pollution
.
Alarm cycles will be reset every time the alarm is disarmed or whenever the
panic alarm is activated
.
5.7 -
SELF-REARMING
When the system is armed and then accidentally disarmed, the system will
automatically rearm 35" after it has been unintentionally disarmed. The
standard acoustic and optical signals will confirm activation.

6.0 - SLEEP MODE ACTIVATION/DEACTIVATION

If the vehicle will be sitting idle for a period of time, the alarm can be switched
OFF (Sleep Mode) to preserve battery life.
To activate the Sleep Mode feature, proceed as follows:
!
Turn ignition key "ON"; the LED will light up for approx. 1".
!
Within 4" of the LED flash, insert the electronic key into its receptable
beep will confirm
the alarm system has been turned OFF.
!
Turn ignition key "OFF".
!
To reactivate the alarm system, turn ignition key "ON" and then "OFF".

7.0 - HAZARD WARNING FLASHERS

To make the turn indicators flash as Hazard warning lights proceed as follows:
!
Turn ignition key "OFF".
!
Then turn ignition key "ON"; the LED will light up for approx. 1 second.
!
While the LED is ON, press remote control button 1.
!
Turn ignition key "OFF"; the turn indicators will start flashing.
!
To disable flashing, turn ignition key "ON" (and eventually "OFF") or arm
the system.
.
MODE
first
3
; a
Page 8

Advertisement

Table of Contents
loading

Table of Contents